digitrax

I am planning on getting the Digitrax Zephyr Express starter set. I want to get the Kato Amtrak P42 starter set - Kato 106-6285 for my first train. Last but definitely not least, I am looking at a decoder for the P42 in that starter set. I found the "N DCC Decoder, Kato MP36PH 6-Function 1A"...

So, I'm starting this thread to as a place to share my decoder installs and get advice on ways to improve on the work that I do.

Analog to DCC conversion - Part 1. This video will show you how to remove the Analog board that comes with your KATO EMD-E9A locomotive and install a Digitrax DN163K0a DCC board. This introduction video will show you what you need to get started. Subsequent videos in this series will have...

I am sure whether my first attempt to post this worked or not... My Digitrax system for some reason doesn't seem to be functioning properly suddenly. The lights are all on, on the front of the Digitrax controller, but I do not seem to be getting any power to the tracks any more. The system...

My DCC Equipment continues to evolve in selection and type of equipment I use. Version 6 highlights my current Digitrax installation using two DCS100 Command stations. The one on the left serves as a power booster. Both boosters feed into PSX circuit breakers which give near instant power off...

My DCC Equipment continues to evolve in selection and type of equipment I use. Version 6 highlights my current Digitrax installation using two DCS100 Command stations. The one on the left serves as a power booster. Both boosters feed into PSX circuit breakers which give near instant power off...

I have a small 8x8 HO Layout that I am running with a Zephyr. I have the Zephyr connected directly to Kato Unitrack. In all my DCC research, there is only mention of DCC Power Bus use with layouts and I am wondering if I am going about this wrong. Should I connect my Zephyr to a power bus and...

what automatic reversing loop machine do you reccomned?? Also where would you place them in this? http://www.windriver-rr.org/trackplan.html i use the digitrax zephyr system if that changes anything...