Power comes to Tootsville !!!

ModelRailroadForums.com is a free Model Railroad Discussion Forum and photo gallery. We cover all scales and sizes of model railroads. Online since 2002, it's one of the oldest and largest model railroad forums on the web. Whether you're a master model railroader or just getting started, you'll find something of interest here.


On the subject of "tricks." I've used this a few times but its now worn out.
Conversation goes something like;
" Bought a new engine today."
"How much did it cost?"
"1200 dollars." says I......
"$ TWELVE HUNDRED DOLLARS!!!!!!!" Says she.
after a pause.... "oh I meant $300........"
"Ah, oh oh that's better"

At that point leave the scene immediately before the penny drops......
 


The thingies are of course glass insulators as those in the photo are power poles, transformers and all. When I was a kid in the early 50's power had only just a arrived in that portion of rural America. However prior to power poles were telephone poles and before those telegraph poles. I think they just added power lines to the existing telephone poles, at least at the start. If I were to make these, I would 3D print the whole arm with the insulators attached, especially in a small scale such as N. HO, maybe one could add separate ones that weren't too overscale.

We always called them telephone poles!
 
Last edited:
I've used glass beads attached with a pin to the side of a round "telegraph pole." HO scale. I've found some real small brass (colored) pins. Your getting down to such a small size that a drop of glue is starting to look out of scale.
 
I tried a few things but the biggest issue I had was getting anything to stick to the top of the cross bar - it was just too narrow. So - all I can now do is glue the wire to the top of the bar and go from there :)
 


Things so far:

ksyMNVd.jpg


tgXbCkn.jpg
 
Have the Power Poles glued in place and ready for the linesmen to come in and put up the wires :)

Not sure when they will be available as I am still in two minds whether to restore this layout and be able to run it or to leave it be. If I restore it, I wont put the wire/line up until the new track work has been done.
 






Affiliate Disclosure: We may receive a commision from some of the links and ads shown on this website (Learn More Here)

Back
Top