chadbag
Well-Known Member
Luckily I've not noticed any performance issues today.
It's a bit cooler today at 85F at 11:30am. I don't know what the high will be but it's been 90s the last week.
I did get a "technical screening interview" appointment sent to me yesterday for the big company I mentioned earlier. This Tuesday. It's tentative pending the technical team confirming the time works for them. It's already been adjusted once. The recruiter assigns a team member from the technical team and a time slot based on the teams calendars, but will then confirm there is no conflict directly with the person, and if there is, will change it.
I mentioned a water leak on our linear "infinity" drain in our wet room. I think I found where it was leaking and applied Semco waterproof membrane with a brush. I need to apply a second coat and then clean the drain and make sure the edges where the tile is and may not be fully covered by the metal flashing is also waterproofed so that the mortar doesn't get wet. Tedious but needs to be done. Also need to see if I can find a 1cm high flat metal flashing about 6-7 feet long so I can install it on the outside tile edge inside the drain in case there is exposed mortar and the water flowing over the edge won't eat that away. It could have been installed better but it is what it is (I didn't install it and the person that did shall remain nameless and role-less).
Tons of work on the house this weekend. No rest for the weary

It's a bit cooler today at 85F at 11:30am. I don't know what the high will be but it's been 90s the last week.
I did get a "technical screening interview" appointment sent to me yesterday for the big company I mentioned earlier. This Tuesday. It's tentative pending the technical team confirming the time works for them. It's already been adjusted once. The recruiter assigns a team member from the technical team and a time slot based on the teams calendars, but will then confirm there is no conflict directly with the person, and if there is, will change it.
I mentioned a water leak on our linear "infinity" drain in our wet room. I think I found where it was leaking and applied Semco waterproof membrane with a brush. I need to apply a second coat and then clean the drain and make sure the edges where the tile is and may not be fully covered by the metal flashing is also waterproofed so that the mortar doesn't get wet. Tedious but needs to be done. Also need to see if I can find a 1cm high flat metal flashing about 6-7 feet long so I can install it on the outside tile edge inside the drain in case there is exposed mortar and the water flowing over the edge won't eat that away. It could have been installed better but it is what it is (I didn't install it and the person that did shall remain nameless and role-less).
Tons of work on the house this weekend. No rest for the weary
