I got everything i need to start working on my new ditch light
-1K resistor, 1/4 amps
-Richmond control surface mount leds
- wire
-acrylic glue
The patient is a CN c44-9w, i was wondering, should i rip off the low ditch light and glue them on the anti-climber ? cause i dont think i ever saw a cn unit with the low ditch light
the ditch light are actually a small cube with a fake grey light, should i dremel out the fake light and glue on the LED ?
and finally... should i put a drop of acrylic glue over the led to make a kind of protection ?
I have a lot of questions because i want to be really really really really well documented to avoid any mistake
-1K resistor, 1/4 amps
-Richmond control surface mount leds
- wire
-acrylic glue
The patient is a CN c44-9w, i was wondering, should i rip off the low ditch light and glue them on the anti-climber ? cause i dont think i ever saw a cn unit with the low ditch light
the ditch light are actually a small cube with a fake grey light, should i dremel out the fake light and glue on the LED ?
and finally... should i put a drop of acrylic glue over the led to make a kind of protection ?
I have a lot of questions because i want to be really really really really well documented to avoid any mistake