F
f1_indy2000
Guest
I have a question on wiring sections. I have attached a picture of where my problem is so I will try to explain it the best i can. I cleaned the track before I started testing it so i know thats not it. So, the three tracks to the left of the parked cars don't work, well one track works. The one that works is to the furthest left. I was hoping to wire all three sets of track together to make one section, but when I did my run through test the engine just stopped. I kind of wonder if the switch has anything to do with it? I put the insulators just before the switch and I have insulators at the end of each set of track. I soddered the wire on the track that works, but I would think if I had created a section the wire should run the current everywhere in that block(between insulators)? So if this makes sense does anyone know where I went wrong? Thanks