AstroKnight187

We all make mistakes; at least you solved the problem and didn't have to spend any more money! 😮‍💨

Maybe you could try a factory reset; or if they might be still attached to address 3, who knows

I don’t use LocoNet or JMRI, but I had a similar issue but with a B-unit. It turned out the decoder was bad, but I’m willing to bet...

My granddads BLI 2-8-0 handles 18” just fine, but 15” might be a stretch

I don't use Plywood. So much of it is warped at the lumber section. I use OSB 23/32 which is between half inch and 3/4 inch. I would...

Standard half inch thick plywood is all you really need, and then you can use Woodland scenics riser starters to meet it, or maybe...

I have Walthers code 100 flex track, it looks much better than Atlas code 100 and it runs just as well; I’d say it’s alright, but if you...

Very nice!!

Roadbed, track, scenery, ballast, catenary.

You can also use it as an extension for a turnout throw. It may of may not be too bendy, but it would be worth a shot. If you don't...

I have this little piece of copper rod that's about 3 and 1/4 inches long and 1/16 of an inch in diameter. It's not precision straight...

Well now we know for sure! Thanks!

Southern Pacific did have DD35s! They had 3, although they were numbered 8400-8402. The Wikipedia article is here...

The oldest locomotive I have is my father’s brass challenger (second shelf from top). All of these locomotives run but they are all DC...

that's a cool collection of duplexes you have there. Bottom right and top right look really neat