Cjcrescent
Master Mechanic
Larry, good you are back to work, but as already said...slow and easy.![]()
NZKEN/Steve: I give up again. What is a Blocky?![]()
![]()
Dadburn Rex, even I know that a blocky is a bricklayer! Or in this case a "block" layer.
Had fun tonight at the McWane Center. I gave part one of my handlying turnout clinic. We had 17 people there, and most did just fine. I have them learning the basic skills to enable them to handlay a turnout anywhere they need one and not be limited to commercial products.
We ran out of time and will pickup where we left off, which was 1/2 way thru building the frogs. After that we will build the points and then I'll get them to may sure everything is in gauge before any soldering gets done. I will also have them make sure the turnout functions properly before the final soldering. If it works before its soldered, it will work afterwards.Its like I told them, building your first turnout is not hard. Its just time consuming.
Meant to add; The title of the clinic is, "We Don't Need No Stinking Templates" Or "Basketweaving in Nickel Silver". Your Choice!
Well gotta go to bed now. Its almost 01:30, and I some things that I gotta do in the morning.
Last edited by a moderator:
