As of yesterday,
I began installing a new control panel I had specially commissioned my workplace to manufacture for me.
In the process, I'd reworked the design to use SPDT Momentary toggle switches to control the Atlas Code 100 turnouts. However, I've run into some minor confusion on the wiring of them. I understand so far that the center wire is wired in series between each toggle on the panel, but I'm confused as to how I need the other leads setup. Can anyone offer any suggestions? I'm using straight DC separated into five electrical blocks
I began installing a new control panel I had specially commissioned my workplace to manufacture for me.
In the process, I'd reworked the design to use SPDT Momentary toggle switches to control the Atlas Code 100 turnouts. However, I've run into some minor confusion on the wiring of them. I understand so far that the center wire is wired in series between each toggle on the panel, but I'm confused as to how I need the other leads setup. Can anyone offer any suggestions? I'm using straight DC separated into five electrical blocks