dpeterson3
Member
Hi all. I found an MS100 at a show yesterday and am trying to get computer control going. Here are the specs for my setup
MS100
DSC50 command station
UR91 reciever
DT400R
I have the MS100 connected to com1 and have JMRI installed. It says I am connected to the layout, but I can not select and run an engine on a throttle. I can't see the traffic on the system either. I can't even toggle between power on and off. Any ideas what is wrong?
MS100
DSC50 command station
UR91 reciever
DT400R
I have the MS100 connected to com1 and have JMRI installed. It says I am connected to the layout, but I can not select and run an engine on a throttle. I can't see the traffic on the system either. I can't even toggle between power on and off. Any ideas what is wrong?
Last edited by a moderator: