Jmri ms100

ModelRailroadForums.com is a free Model Railroad Discussion Forum and photo gallery. We cover all scales and sizes of model railroads. Online since 2002, it's one of the oldest and largest model railroad forums on the web. Whether you're a master model railroader or just getting started, you'll find something of interest here.


D

dpeterson3

Member
Hi all. I found an MS100 at a show yesterday and am trying to get computer control going. Here are the specs for my setup

MS100
DSC50 command station
UR91 reciever
DT400R

I have the MS100 connected to com1 and have JMRI installed. It says I am connected to the layout, but I can not select and run an engine on a throttle. I can't see the traffic on the system either. I can't even toggle between power on and off. Any ideas what is wrong?
 
Last edited by a moderator:
dpeterson3,

there is a Yahoo Web site for JMRI, Perhaps you should pose your question with them. I have not used MS100 so really don't know what the parameters that you need to get things going. I am sure someone over there knows what you need.

Bob
 
The biggest thing is in the preferance making sure you have it set for the MS100 so JMRI know's what it's talking to and as well as the kind of command station and then the fun part of what comm you are on. But once you get it set then you should be good to go with everything without issues.
 
You must log in or register to reply here.




Affiliate Disclosure: We may receive a commision from some of the links and ads shown on this website (Learn More Here)

Back
Top