Digitrax throttle

ModelRailroadForums.com is a free Model Railroad Discussion Forum and photo gallery. We cover all scales and sizes of model railroads. Online since 2002, it's one of the oldest and largest model railroad forums on the web. Whether you're a master model railroader or just getting started, you'll find something of interest here.


new engine on track powered up dcs51 / pluged in cable to the dt602 / hit power button on dt602 no screen light up . touched cable connection into the dt602 then it lit up . stole the engine and advanced throttle engine proceeded to run around track and stopped 5 times going around . shut down throttle and ran with the dcs . engine did not hiccup once , no issues at all all three loops again . the cable ? ( the issue trying to turn on the dt602 . im going to try digitax help desk . could i try a phone cable that i have ?
mike
Oh! that's annoying, but at least you've narrowed the problem down.

It may not be the cable could be a loose wire in the dt602 socket, I wouldn't suggest trying another cable till you hear back from them, just in case using another cable makes it worse.
 
Weird thing is the dt602 would say % of power as if I went from 25 % to 30% and train would move again but the stop somewhere else on track until i move throttle again .. Dcs51 was constant no matter where I left speed handle , crawling along it would crawl all the way around layout .
 


Weird thing is the dt602 would say % of power as if I went from 25 % to 30% and train would move again but the stop somewhere else on track until i move throttle again .. Dcs51 was constant no matter where I left speed handle , crawling along it would crawl all the way around layout .
That's why I'm thinking there's a problem with the dt602, either cable/socket or internal.
 
Weird thing is the dt602 would say % of power as if I went from 25 % to 30% and train would move again but the stop somewhere else on track until i move throttle again .. Dcs51 was constant no matter where I left speed handle , crawling along it would crawl all the way around layout .
If you used the steal button , the loco address will still be selected on the dcs51 and you will get situation. Be sure to dispatch/or release the adress from the DCS 51. I hope this helps. Jon
 






Affiliate Disclosure: We may receive a commision from some of the links and ads shown on this website (Learn More Here)

Back
Top