Hi;
I have a few Atlas N scale Master Series freight cars and one of them took a header off the table. When it hit the floor the trucks and mounting pins separated and flew in separate directions. I found the trucks and pins but not the metal washers that go between the mounting pin and bolster. Without the washers the axles tend to rub on the coupler pocket a bit. I measured one from another car and they are ~ 0.016" thick. Does anyone know where I could find these N scale washers? I couldn't find them on the Atlas website. Thanks.
I have a few Atlas N scale Master Series freight cars and one of them took a header off the table. When it hit the floor the trucks and mounting pins separated and flew in separate directions. I found the trucks and pins but not the metal washers that go between the mounting pin and bolster. Without the washers the axles tend to rub on the coupler pocket a bit. I measured one from another car and they are ~ 0.016" thick. Does anyone know where I could find these N scale washers? I couldn't find them on the Atlas website. Thanks.