problem


  1. S

    Ballasting Problem: Scenic Express N Scale Blended Ballast Clumps up When Gluing No Matter What I Try

    Hi there, I'm new to this forum, so please let me know if this isn't the right place to post this. I am in the finishing stages of my first HO scale layout, but when ballasting a section of my track with Scenic Express's N scale blended ballast I ran into a major issue despite following my...
  2. OWilks1

    Roundhouse 0-6-0 shorting out and motor stalling

    Hi all, first post here. Just working on 2 supposed roundhouse tender 0-6-0's and they both short circuit when running for a tiny bit. One of them also has a motor that will stall and only run for a tiny bit if i give it a little spin myself. While stalled, the motor starts to get really hot as...
  3. S L

    Difficulty with Atlas Turnouts That Will Power on, but Fail to Actually Switch (They Used to Work!)

    Very new to the MRRF, very new to forums in general, etc; so apologies in advance. Anyways, the issue I am having is quite infuriating, but I am not engineer for anything so I have to ask for help, and hope that you guys might have some ideas. Here is the issue: The setup shown in the pic...
    • S L
    • Thread
    • atlas atlas track gomen nasai help problem question
    • Replies: 8
    • Forum: General Discussions



Back
Top