Search results

I probably should have considered this before I planned my benchwork, but now I'm stuck. I purchased a bunch of Atlas under table machines, and would like to stick with them. However, my benchwork is too thick. It's 1/2" plywood with a 1" foam board glued to the top. Add the thickness of roadbed...

Looking for anyone who has recommendations for CV settings to get the most out of my Tsunami AT-1000 decoder. I have set the correct horn and slowed the bell down, but what else should I change?

I have two Atlas New England Central units, numbered 9537 and 9528. Since they were produced, NECR changed their numbers to 3855 and 3848. I'd like to change the number boards and the NECR and numbers on the cab sides to match the font used on these two locos. Any suggestions as to where I can...