Walthers Double Track Swing Bridge, assembly question?
This is the bridge I am speaking of,.... https://www.walthers.com/double-tra...t-27-x-6-3-8-x-7-9-16-quot-69-x-16-2-x-19-3cm
On that site there is also a downloadable PDF assemble instruction sheet.
The question that has come to my attention concerns a relatively small part, 2 deck end pieces, that exist at either end of the bridge. I am wondering if any other owner of one of these bridges has experienced the same question.
This is the questionably part(s)
I believe I have installed them correctly, BUT they are a bit too proud for the track that installs on the bridge beams??
This is the bridge I am speaking of,.... https://www.walthers.com/double-tra...t-27-x-6-3-8-x-7-9-16-quot-69-x-16-2-x-19-3cm
On that site there is also a downloadable PDF assemble instruction sheet.
The question that has come to my attention concerns a relatively small part, 2 deck end pieces, that exist at either end of the bridge. I am wondering if any other owner of one of these bridges has experienced the same question.
This is the questionably part(s)
I believe I have installed them correctly, BUT they are a bit too proud for the track that installs on the bridge beams??