Probably in your standard set, between 3/8 and 7/16...Where the heck is my danged 10mm deep socket?![]()
BTW, happy birthday. I think it was over the weekend.
Probably in your standard set, between 3/8 and 7/16...Where the heck is my danged 10mm deep socket?![]()
I just switched our AprilAire to Winter mode and cleaned the water pad 10/1 when I switched the heating system on. It only runs when the humidity goes down below 30, I think. I’d have to check the settings in the manual. The air conditioning unit has the AprilAire unit attached because the house is radiant heat, the A/C has the duct work so they put the humidifer on that.Troy that's how it should be connected only when heat called for Never on the fan setting Should have been a connection on the board in the furnace for that
All the wiring should be right there on the furnace
And AprilAire are fine just make sure you change the water pad each year They tend to get limed up and also have a chemical coating that only lasts for about a year and do you have a humidity sensor on it ?? Should be mounted on the cold air return something like one of these
Anything close up I use pre painted figures, background hand painted.I have some for the construction site, but the track workmen are all unpainted, and I'll never learn anything if all I do is buy everything pre-made or painted am I ?
I highly doubt they separate stuff in the dump.In the Town that the property we live on is at says throw everything in the garbage bin as it’s easier now for the sorters to separate stuff at the dump.
Both use the same County wide dump!
Low flush toilets, low flow washing machines and other low flow stuff is causing problems in the sewer main due to not enough water to push the paper and Lincoln logs down the line. Baby wipes are another problem.When ya go light on the water that would normally go down the drain, your pipes will begin clogging. Not enough water to push stuff out to the main sewer line or to the septic tank.
Ya don't know it until there's a month or so of flushings in the pipes. Each subsequent flush will fill the pipes and just gradually drain or soak through the blockage but not back up all the way to the drain where you would see it. When it eventually does breach your kitchen sink drain, no amount of plunging is gonna move a month or so worth of stuff.
They have lots of building you can see from the interstate, but I would think the Waste hauler would do that? But I read when we got the new hauler it was at the dumpAnything close up I use pre painted figures, background hand painted.
I highly doubt they separate stuff in the dump.
My 2016 Equinox LTZ does as well. 3 tires at 29lbs and the 4th at 31. All at 35 now.My Pacifica tells me which one, and gives me a graphic showing all four tires and their pressures. It's nice but I usually end up airing all four tires up a little anyway. Then there's the day it will finally fail. Wonder how much that'll cost me?![]()
yep. We have the humidistat. And there were reasons the furnace guy was cussing.Troy that's how it should be connected only when heat called for Never on the fan setting Should have been a connection on the board in the furnace for that
All the wiring should be right there on the furnace
And AprilAire are fine just make sure you change the water pad each year They tend to get limed up and also have a chemical coating that only lasts for about a year and do you have a humidity sensor on it ?? Should be mounted on the cold air return something like one of these
Mike: Staying on is just a guess. With a new, properly installed, properly seated filter, and an otherwise properly working furnace system, that is my latest guess for something that mysteriously happens once a year over the past 3, and three times last year. There was not a whole lot of water but enough that I had to squeegee it to the french drain. A new water valve would be cheaper than a whole unit. I'll see what the tech thinks when he gets here Friday. Thanks for the heads up.Not sure why it would stay on shouldn't be able to the valve runs on 24 volt from the furnace The only thing I can think of is the water valve was sticking open very likely Those valves some won't last two years So you might just need that replaced cheaper then the whole unit
@MikeInHubCity, post #879: Well, it was obviously dam*ed...er..."danged"...to the lower realms. That's why you can't find it.Probably in your standard set, between 3/8 and 7/16...
BTW, happy birthday. I think it was over the weekend.
One other possible and I had one do this the valve was ok but the drain line got enough lime deposits in it and got plugged up so had water dripping out from the unit Not sure which model you have but check that drain line Most are clear tubing if it is plugged up just replace itMike: Staying on is just a guess. With a new, properly installed, properly seated filter, and an otherwise properly working furnace system, that is my latest guess for something that mysteriously happens once a year over the past 3, and three times last year. There was not a whole lot of water but enough that I had to squeegee it to the french drain. A new water valve would be cheaper than a whole unit. I'll see what the tech thinks when he gets here Friday. Thanks for the heads up.
Well...there you go. You said it just the way it should be said. And she sure did too: "you did not always get everything you wanted but you always had what you needed." Wow!Hey Everybody,
We are doing ok. Our faith assures us my Mom is in heaven. We are relieved her suffering is over.
The hardest part of all this was to see her suffer, trapped in a bed and we could do nothing to help her. She was independent right up until last Monday morning when she called us to take her to the emergency room.
Since my sister passed away in 2007 and my Mom moved close to me, I always made her my priority. I did/fixed whatever she needed, usually the same day she asked. She often said "you don't have to do it today. I don't want to be a pain" You could never be a pain Mom.
I miss her, I knew for the last two years the end was near. She lived a good life. She worked hard, sometimes two or even three jobs. and always did her best. One of the things she told me in the last days was "you did not always get everything you wanted but you always had what you needed." I replied, "and much more" Her example is where I get my work ethic. Thank you Mom.
There have been a lot of tears and there will be more. She was a big part of our everyday life. We are reminded of her in many things we see and do each day. My wife and my Mom were remarkably close. I told the hospice nurse "I am her security blanket, my wife is her best friend"
Thank you, God, for such a wonderful mother.
I saw that yesterday on some Microsoft news feed, but he died on July 28, 2021. Fake news!Good morning, it's clear and 40.
Dusty Hill from ZZ Top has died.
Not fake, but certainly recycled.I saw that yesterday on some Microsoft news feed, but he died on July 28, 2021. Fake news!
