As I mentioned, our Wednesady pour was successful. A few places need a little extra concrete but all in all we are good to go. The frames will set the roof beams this week Tuesday or Wednesday.
The day after the pourm the guy who I hired whose been helping me with his son and who led the pour brought his drone down and took some shots...
The non aerial shots are from today (Sunday) -- they show most of the outer bracing and strapping and stuff removed.
Friday and Saturday my son and I worked on putting the yellow bracing back in their racks (the ones not used or already taken down -- ones supporting strucures newly poured will remain up a few more days while the concrete continues to set). We also did a ton of clean up and filled our dumpster with foam and scraps of lumber and chunks of concrete and plastic sheeting we used to protect the floor from concrete spills and splatters. We also mixed uyp 1/2 a bag of concrete I had in the basement (the other half absorbed water from the winter and was hard) and mixed in 1/4 of a new bag -- the hired help and dropped off some bags Friday but for some reason didn't get to putting it in where small areas needed it and one bag had broken open so we scooped up most of that to use with our other stuff -- all together we got about 4-4.25 gallons in a 5 gallon bucket and we did one of the places that was missing some plus filled in a few depressions on some other walls that had minor areas to add in a little. Mostly where we had used boards to be able to fill in on the angle of the roof line and the vibrating didn't quite get it all pushed in every where under the board.
Tomorrow (Monday) I have a guy coming buy to make an estimate and sell us on his garage coating product and service. We need to get our garage floor coated and "waterproofed" so we don't get water leakage into the basement space underneath the garage. This place uses something called "polyurea" and they claim it is the best thing since sliced bread. We're see what they say and what their cost estimates are.
Does anyone know anything about this "polyurea" coating vs the traditional "epoxy" type coatings most garage coating places try and sell you on?
I'm also going to have him show me and estimate their cheapest solution for our store room and my work rooms in the basement. Don't know if I'll have the money for that area of the house but want to get an estimate to see as it will be easier now than later and would like to get something done to those places we're not going to put flooring on...
Done shots from Thursday:





Todays exterior shots after removal of some of bracing/strapping/support joists etc:


