Well, howdy there internet peeps and those still foggy,
It's Troy again...
Tried out the new Ninja coffee maker today. The brew is hot! One reviewer on the youtubez stuck a themopen in both the basket and the carafe while brewing and it was near 197° f when hitting the grounds. So, it is hotter than my old Cuisinart. That topped out at 192°F and slowly degraded over time.
I should have tried a cup without cream, but I put the half-n-half into the thermal pot right after I poured the coffee in. Tomorrow I'll try a cup flat black, then doctor it up. What I have with my cream and sweetner is good.
One thing I like about the Ninja is the Keep Warm button. Basic coffee makers with glass carafes default to keeping the warmer plate on for X time. Those with Stainless steel carafes default to turning the warmer off right after brewing (the stainless steel pot is thermal insulated).
The ninja defaults to on, but If I do depressment of the
Keep Warm button, it unlights itself, and the warmer turns off as soon as the brew is complete. Since I transfer the brew to a thermal pot for travel to the basement, the warmer doesn't need to be on.
It's laundry day here. and I need to paint some toy soldiers.
These guys are up next:
Religious zealots that hit hard but lack armor.
So, of course, I fired up the 3D resin printer and added some more "colorful" characters you might recognize from the Flying Circus of Monty
I have a bunch of the "comfy pillows" printed up, and shall be swapping some of the swords out. "Poke them with the Fluffy Pillows"