Unable to Reset NCE DN14IP Decoder

ModelRailroadForums.com is a free Model Railroad Discussion Forum and photo gallery. We cover all scales and sizes of model railroads. Online since 2002, it's one of the oldest and largest model railroad forums on the web. Whether you're a master model railroader or just getting started, you'll find something of interest here.


B

bigB

Active Member
Hello All,

I pulled a DN14IP decoder (8 pin) out of another loco, and put it into a Athearn Genesis. At first it worked fine with the old loco's address. So I went to change it to the new loco's address, and it know longer responds except for the front headlight. I tried to do a factory default reset (cv30 to 2) but the loco still responds to the new address, not address 3. Also, still no movement on new address or 3, only the light. Ive emailed nce support, but havent heard.

Any ideas?
 
Nevermind, I figured it out. Turns out decoder used to be in a locomotive that was in the middle of a consist. Just deleted the consist, and it works again.
 
You must log in or register to reply here.




Affiliate Disclosure: We may receive a commision from some of the links and ads shown on this website (Learn More Here)

Back
Top