Switch Mess

[Sweet-Chuck]

Hi everyone. I recently tore down my layout as I found it a bit bland.
This time around I am trying to incorporate switches!!!! (yikes)

If anyone can direct me into wiring this I would be quite grateful. I was thinking some colored lines for the power, and then marking where it should be connected with insulated rail joiners?

I am using DCC, and all switches are #4, except for the one noted #411, which I believe is insulated as well.

I have included my drawing for easy reference, but actual pics as well.

Thank you so much!!
Sweet Chuck

 

[Cjcrescent]

These all appear to be Atlas and Atlas copies, meaning they are like you said insulated. There is no need for gaps between these turnouts. I would place a feeder on each line between the turnouts and go from there. The frogs are dead, so there is no worries about shorts.

 

[timlange3]

Yes, some appear to have plastic frogs and some unpowered metal frogs. So if you don't have power routing turnouts there is nothing you need to insulate.