dukesterpro
New Member
Hi everyone!
Last night I installed an Eco-PNP into my Stewart FT. Everything worked great. It ran around the layout for about 6 hours. I took it off the layout and put it back in its display case and went to bed. This morning I set it back on the track, the headlight comes on kind of dim. The prime mover fires up. But I have no control. Occasionally the mars light will flicker but other than that it will just idle.
Here is what I have tried
-Resetting the command station
-resetting the decoder (blue pilot light on the board turns on as well as the headlight and then shuts off) (on programming track)
-checking speedsteps
-verifying wiring is correct
-decoder was never locked and appear to be taking programming commands
-no red error light, just no response
Where do I go from here?
Thank you,
Dugen
Last night I installed an Eco-PNP into my Stewart FT. Everything worked great. It ran around the layout for about 6 hours. I took it off the layout and put it back in its display case and went to bed. This morning I set it back on the track, the headlight comes on kind of dim. The prime mover fires up. But I have no control. Occasionally the mars light will flicker but other than that it will just idle.
Here is what I have tried
-Resetting the command station
-resetting the decoder (blue pilot light on the board turns on as well as the headlight and then shuts off) (on programming track)
-checking speedsteps
-verifying wiring is correct
-decoder was never locked and appear to be taking programming commands
-no red error light, just no response
Where do I go from here?
Thank you,
Dugen