ModelRailroadForums.com is a free
Model Railroad Discussion Forum and
photo gallery. We cover all scales and sizes of model railroads. Online since 2002, it's one of the oldest and largest model railroad forums on the web. Whether you're a master model railroader or just getting started, you'll find something of interest here.
Is there a puller or something to pull the flywheel off of the motor.
I have tried the screw driver under the flywheel and motor.
I keep bending the armature.
Thanks,
Dale
Gomez Addams
Staff member
Well-Known Member
Staff member
I hope you haven't bent the motor shaft, it will be extremely difficult to straighten it accurately if so.
bnsf971, I just bought one of those from Micro Mark.
toot, I think I messed up the hole in the flywheel.
It will not stay on now.
Well-Known Member
Staff member
bnsf971, I just bought one of those from Micro Mark.
toot, I think I messed up the hole in the flywheel.
It will not stay on now.
Unfortunately this is a job where there is a right way and the only wrong ways do damage. If the shaft is bent even by the slightest bit (you won't detect that by eye), the flywheel will wobble and cause vibration when turning at speed, just like an out of balance wheel on a car.
Affiliate Disclosure: We may receive a commision from some of the links and ads shown on this website
(Learn More Here)