Newbie's 1st Decoder Inst.......


SPfan

SPfan

Member
I was able to get my first decoder in (if a Digitrax plug n play counts). By the way, I'm assuming NOW that the 6" harness included is for older Athearns. Anyway, I was trying to be very careful, but the headlight wiring came loose from the cab. I tried (unsuccessfully) everything I could think of, even tweezers, but could not get both bulbs back into holes. Has anyone ran into this problem? Any solutions? Also, Athearn now has "DCC harness installed" vs "Quick Plug Equipped". Is this still a plug n play install?

Thanks in Advance................All this DCC has my last brain cell working overtime!!!!!!!
 
Last edited by a moderator:
Thanks.....

Thanks Spacemouse. You're right, probably just blowin' off some steam from something that should've been so darn easy. I guess I should've asked about experience replacing a headlight bulb on Athearns. (That may be my solution right there). I have put the shell back on, but I will try and post a pic soon-or just deal with 1 headlight:) .
 
You must log in or register to reply here.



Back
Top