hi i would like to use ESU Switch pilot to control my peco motors but reading the online manual it says the following
"9.3. Configuration of an output for PECO solenoid drives If you wire a PECO solenoid drive to an output write the value 1
into the corresponding configuation-CV. This adjusts the overload
(over current) protection to the higher values for PECO solenoid
drives."
what does this mean and how do i do it? i am using bachmann dynamis
"9.3. Configuration of an output for PECO solenoid drives If you wire a PECO solenoid drive to an output write the value 1
into the corresponding configuation-CV. This adjusts the overload
(over current) protection to the higher values for PECO solenoid
drives."
what does this mean and how do i do it? i am using bachmann dynamis
