Hey all,
I am wiring up my layout before I get my Digitrax Super Chief Xtra and I needed your expertise on something.
I have a 12ga braided bus, and I'm planning on using 18ga feeders. Is this too much power? Is that even possible if it comes out of the 5a super chief booster?
I am running HO scale, I have loops on a 8'x13' square with the operation center in the middle of the loop, so at any point the absolute furthest the bus is away from the booster is 20' max.
I do have 20ga wire if the 18ga is too big, but I was planning on using the 20ga for accessories/turnouts, etc.
thoughts?
I am wiring up my layout before I get my Digitrax Super Chief Xtra and I needed your expertise on something.
I have a 12ga braided bus, and I'm planning on using 18ga feeders. Is this too much power? Is that even possible if it comes out of the 5a super chief booster?
I am running HO scale, I have loops on a 8'x13' square with the operation center in the middle of the loop, so at any point the absolute furthest the bus is away from the booster is 20' max.
I do have 20ga wire if the 18ga is too big, but I was planning on using the 20ga for accessories/turnouts, etc.
thoughts?