Atlas Commander DCC system problem

ModelRailroadForums.com is a free Model Railroad Discussion Forum and photo gallery. We cover all scales and sizes of model railroads. Online since 2002, it's one of the oldest and largest model railroad forums on the web. Whether you're a master model railroader or just getting started, you'll find something of interest here.


PEIR

PEIR

Eastern RailNet
I have an old Atlas commander that I use for programming (2' section) and testing locomotives (10' section) of track. I tried to program a C424 with NCE decoder and when I went to test the unit it took off at full speed. I tried a previously programmed unit that had worked fine and it did the same thing as did a unit with no decoder at all. The display shows "Con" and "ER 9" when it is plugged in and will not turn off unless unplugged.

Is there a way to do a factory reset on the system or do I have one of the settings screwed up? I don't have a layout and don't want to buy a new system unless it is absolutely necessary so any help would be greatly appreciated.

Stephen
 
Thank you for the help Mark! The con and er 9 were in lower case not upper like I had typed but you knew what I was talking about anyway:o Everything is working the way it is supposed too:cool:
 
You must log in or register to reply here.




Affiliate Disclosure: We may receive a commision from some of the links and ads shown on this website (Learn More Here)

Back
Top