AstroKnight
i am speed
Hi guys,
Just got a digitrax decoder for my locomotive, a 9-pin one. I’ll update this post later on what model it is.
Anyway, last night I set it to the cab address, 6122, and it ran fine.
Fast forward to this morning, I put it on the tracks to test it out; the NCE had locomotive 3 ready, not sure why. I selected road number 6122, and it did nothing. I went back to locomotive 3, and it responded. I then tried changing the address back to the cab number, and the locomotive acknowledged that a change had been made. But, I go to run it, and it doesn’t do anything. I see if it’ll respond to Address 3, and it does.
TLDR; Locomotive only responds to Address 3 instead of the cab number I set it to.
I am using an NCE Powercab.
Is there a way to fix this?
Just got a digitrax decoder for my locomotive, a 9-pin one. I’ll update this post later on what model it is.
Anyway, last night I set it to the cab address, 6122, and it ran fine.
Fast forward to this morning, I put it on the tracks to test it out; the NCE had locomotive 3 ready, not sure why. I selected road number 6122, and it did nothing. I went back to locomotive 3, and it responded. I then tried changing the address back to the cab number, and the locomotive acknowledged that a change had been made. But, I go to run it, and it doesn’t do anything. I see if it’ll respond to Address 3, and it does.
TLDR; Locomotive only responds to Address 3 instead of the cab number I set it to.
I am using an NCE Powercab.
Is there a way to fix this?
