Recent content by regme

Hi I would do a quick google search, there should be some info out there about what your trying do. At a pinch, I used Hornby and Peco turnout motors (not sure if the Atlas ones work the same way) also had the old Lima points which also required the following to work. a Capacity Discharge...

Thanks, I get the backdrop approach, not a 100% on the "behind the viewer" may need to find an example of that.

Thanks Dave1905 - I'm entirely sure what you mean. So I need to extend the layout out for the pipework?

Hi I bought these two kits Kibri MIRO Storage Tank Kit (39832) ages ago. As it turns out I'm about 10 times smaller than what I thought I needed. The prototypical tanks is about 3000m3 vs the kit 340m3. So I'm unsure about whether to cut my losses or just go it. I have thought about...

Hi Have almost completed the siding into the car dumper, next is the TLO. Just have to paint the tunnel portals and batters. to get started on that. Cheers

That's the biggest one, I have a small radii at 480mm

Can you take a pic on the instructions?

Thanks, I thought that cutting the rail on a curve it would kink the rail.

Hi I was explaining this to a mate at I was going to use PCB cut into sleeper size pieces and replace the plastic ones over the joint and solder the rail to the sleeper, and he asked why? Why don't you glue the plastics ones and cut through them? There seems to be no difference between the...

Hi Finally started laying down track. Have all the points down and started on the curves. When creating joints in the tracks for modules how many sleepers would you back from the joint? Cheers

Hi Finally, managed to get the batters in at the tunnel entrances. Hopefully will start laying track.

Thanks

Yes they are, well worth the investment into a printer

Got side tracked, and started on the two tunnel portals I need. Managed to come up with these.

Hi No worries Cheers