Recent content by LyleB

The tape was used exactly as described both in the instructions and in Mike Fifer's YouTube video. Wrapped around the outside of the brass power rails, covering bottom, side and top completely where the motor connectors touch it.

I've been trying to install a digitrax decoder into my Kato E5A. Have put it in and taken it out three times. Locomotive works with the original light board installed on DC, Is completely dead with the digitrax installed and tested on dcc. I've given up. May be a faulty decoder, but I have no...

Hello, I'm starting work on my first layout. I actually started many years ago, but got side-tracked, so I'm starting again. I recently purchased Kato Unitrack for the basis of my layout, and I'm happy with what can be done with weathering and ballasting. I do, however have about 30 pieces of...