GeeTee
Well-Known Member
I was searching for a way to layout complex curves for my mainlines and backdrops . I could have printed out the whole layout but thats a lot of paper and toner.
Cost for the tool was just under $10.
I isolated the mainline in my CAD tool software and overlayed a 6 inch square grid.
locating a few points where the mainline crosses the grid , I then transfered those to the layout and staked them out with toothpicks .
Cost for the tool was just under $10.
I isolated the mainline in my CAD tool software and overlayed a 6 inch square grid.
locating a few points where the mainline crosses the grid , I then transfered those to the layout and staked them out with toothpicks .