I have several unopened Atlas S2 switchers I acquired several years ago with the intent of detailing them and repainting them UP. In my first look at them in about 10 years, it's obvious the first thing that needs to occur is the removal of the cast grab irons. I believe it's called "shaving them off".
My first question is what's the best technique for doing this? I never tried it before.
My second question is in regard to spacing the holes for installing grab irons. They need to be pretty precision to look good. I'm thinking of not only adding grabs to the S2, but later to some Stewart FTs as CB&Q Graybacks. I've seen some excellent work here, so there must be a technique for getting the holes drilled in the right place.
Appreciate any suggestions
Deane
My first question is what's the best technique for doing this? I never tried it before.
My second question is in regard to spacing the holes for installing grab irons. They need to be pretty precision to look good. I'm thinking of not only adding grabs to the S2, but later to some Stewart FTs as CB&Q Graybacks. I've seen some excellent work here, so there must be a technique for getting the holes drilled in the right place.
Appreciate any suggestions
Deane