IronBeltKen
Lazy Daydreamer
I just installed an additional UTP panel to my NCE PHPro-based layout. Because of the increased cable length, some of my UTP's that are farther away from the command station have become unresponsive. The NCE website says to plug-in a 12VDC - 1amp "wall wart" (NCE p/n P114) power supply in the socket on the rear. Ok, that sounds simple enough...
My question is: Do I need a P114 for every one of the UTP's that are too far away from the command station? Or, since they are daisy-chained together, will a single P114 suffice for the adjacent UTP's in addition to the one where I plug in the P114?
Any feedback is greatly appreciated...
My question is: Do I need a P114 for every one of the UTP's that are too far away from the command station? Or, since they are daisy-chained together, will a single P114 suffice for the adjacent UTP's in addition to the one where I plug in the P114?
Any feedback is greatly appreciated...