GOtransitfan
New Member
PC connection problem with Locobuffer and Superchief
Hello everyone
I just get my new super chief (5 amps) duplex radio DCC system.
im familiar with the system as our local club have the exact system, so after few tests i decide to connect the DCC system to my PC using a locobuffer (locobuffer II- RS232 cable)
im using win xp as operating system, and RR&CO. as a control and operation software.
anyway, after all the connections are done, the locobuffer showed 2 green LEDs one power indicator, and one loconet indicator on, but the third LED, which show loconet signal stay off all the time.
as it appear, the RR&CO. software succeed to connect the DCC system as it showed that at the status bar
can any one give me any ideas of why the trains didn't move at all?
Hello everyone
I just get my new super chief (5 amps) duplex radio DCC system.
im familiar with the system as our local club have the exact system, so after few tests i decide to connect the DCC system to my PC using a locobuffer (locobuffer II- RS232 cable)
im using win xp as operating system, and RR&CO. as a control and operation software.
anyway, after all the connections are done, the locobuffer showed 2 green LEDs one power indicator, and one loconet indicator on, but the third LED, which show loconet signal stay off all the time.
as it appear, the RR&CO. software succeed to connect the DCC system as it showed that at the status bar
can any one give me any ideas of why the trains didn't move at all?
Last edited by a moderator:
