Gdelmoro
Member
Hi all, I posted this on another site also hoping to get some ideas. I have 6 DCC locomotives. 3 Steam and 3 Diesel. Only 1 stops at this same spot on a very slight mainline curve.
Right about where the mark is. That curve is really about a 38* radius. There is a gap just prior to that spot but both sides have feeders.
The two 282's, two SW1500's and the SD7 blow right through. The 462 Pacific stops then sometimes will start up again on it's own after about 3 seconds.
Any ideas?
Right about where the mark is. That curve is really about a 38* radius. There is a gap just prior to that spot but both sides have feeders.
The two 282's, two SW1500's and the SD7 blow right through. The 462 Pacific stops then sometimes will start up again on it's own after about 3 seconds.
Any ideas?