Two-Tone-Green
New Member
Hey guys most of you prob. know me from RRF, same user name and everything..
So I got Proto 2000 0-8-0 (as seen in picture) and I got it a while ago go now. I got interested in Models in elementary school, then never had time to do it in High School, So recently I took it out again saying this time there is no turning back!
Here is my 5min job of putting my layout together just to run my steamer, the only problem is that hen I'm switching or going around the oval it seems to be quite "jerky", When its alone its far more "jerky" but if it has a good sized train (6 cars) it still does this problem but to a lesser extent. Also the Light on the front of the unit also flickers with the jerkiness.
Yes the track is clean and I have cleaned the Unit to a little bit of improvement.
I also have 2 Kato BCR SD40-2's and a C425 but they aren't here, so I assume its the Steamer, any advice on what I should do?
Thanks in Advance!
So I got Proto 2000 0-8-0 (as seen in picture) and I got it a while ago go now. I got interested in Models in elementary school, then never had time to do it in High School, So recently I took it out again saying this time there is no turning back!
Here is my 5min job of putting my layout together just to run my steamer, the only problem is that hen I'm switching or going around the oval it seems to be quite "jerky", When its alone its far more "jerky" but if it has a good sized train (6 cars) it still does this problem but to a lesser extent. Also the Light on the front of the unit also flickers with the jerkiness.
Yes the track is clean and I have cleaned the Unit to a little bit of improvement.
I also have 2 Kato BCR SD40-2's and a C425 but they aren't here, so I assume its the Steamer, any advice on what I should do?
Thanks in Advance!
Last edited by a moderator: