I got one new in the box still wrapped neve open. It arrived on the 26th of may. I can see the bracket for the cab light is not in position. Today I finally decided to power up the loco touching the power pack clips to one set of wheels. I hear and feel the cab end truck rattle unless I tilt it up or turn it to either side. The wheels all work on both trucks and the cab noisy one the gears seem to be fine. It seems like something is maybe touching the cab end drive shaft or maybe the worm clip is not fully seated .
I see the 4 tabs through the frame above the trucks , do I just push them in from the side? The instructions say to. I have never had one apart before and don't know if you push one tab then the other on the same end or same side.
Normally I would just go for it yet this seems a bit more tricky than most I've done and I don't want to break anything.
Any help would be great.
I see the 4 tabs through the frame above the trucks , do I just push them in from the side? The instructions say to. I have never had one apart before and don't know if you push one tab then the other on the same end or same side.
Normally I would just go for it yet this seems a bit more tricky than most I've done and I don't want to break anything.
Any help would be great.