Hi Guys:
I am getting ready to start installing my main buss and a few of the sub busses and hopefully laying some track in the next couple days!!!
the layout is U shaped around the wall. As I pull in the main buss that is attached to the plug panel where the NCE power cab plugs in, the buss will go 2 directions from the plug panel -- when I get out to the end of the layout, should I just terminate it at a terminal block or is there some special way to terminate it? im using the method that Ron describes on Rons Trains and Things
Thanks
TIM
I am getting ready to start installing my main buss and a few of the sub busses and hopefully laying some track in the next couple days!!!
the layout is U shaped around the wall. As I pull in the main buss that is attached to the plug panel where the NCE power cab plugs in, the buss will go 2 directions from the plug panel -- when I get out to the end of the layout, should I just terminate it at a terminal block or is there some special way to terminate it? im using the method that Ron describes on Rons Trains and Things
Thanks
TIM