Fishplate
Member
Here are a couple of photos of my new DCC wiring panel. Tony’s Train Exchange had a sale on Lenz equipment over the holidays, so I went ahead and ordered my control system.
The main components are a DCC Specialties MF615 power supply, Lenz LZV100 command/power station, and a CVP ZoneShare ZS4X circuit breaker/reverser board. The ZS4X has outputs for three breaker-protected sections plus one reversing track.
The panel is ½” MDF. I secured the power supply with 14” cable ties through holes in the panel. A piece of ¼” scrap wood glued to the panel keeps the power supply from sliding down.
The terminal strip acts as a junction block using jumpers and quick-disconnect terminals bought from drillspot.com. The idea is to eliminate any track bus splices at other locations.
View attachment 12093
This rear view shows the shelf that supports the Lenz command station. This will eventually be hidden by a backdrop.
View attachment 12094
The main components are a DCC Specialties MF615 power supply, Lenz LZV100 command/power station, and a CVP ZoneShare ZS4X circuit breaker/reverser board. The ZS4X has outputs for three breaker-protected sections plus one reversing track.
The panel is ½” MDF. I secured the power supply with 14” cable ties through holes in the panel. A piece of ¼” scrap wood glued to the panel keeps the power supply from sliding down.
The terminal strip acts as a junction block using jumpers and quick-disconnect terminals bought from drillspot.com. The idea is to eliminate any track bus splices at other locations.
View attachment 12093
This rear view shows the shelf that supports the Lenz command station. This will eventually be hidden by a backdrop.
View attachment 12094
