DCC Reversing loop help please

[Rocky Lines]

Hi,
I have built an HO scale layout that looks some what like the ruff sketch I am attaching. I have one functioning reversing loop at this time. I know that I have at least one, if not two additional reversing loops because of shorts I am experiencing. Please help me identify the additional reversing loop, if there is only one. I am thinking that there may be two that I need to adjust for. I am hoping that the second reversing loop I wired for can be adjusted to fix my shorts. Any help or suggestions would be helpful. I am using MRC reversing loop modules for these reversing loops, if this matters.
Thanks.
Mike
Rocky Lines

 

[Rico]

Yes there are two right where you marked them.
I'd extend the line for reverse section number two just a little.

 

[Rocky Lines]

Thanks for the reply. How do the changes I made look?

 

[UPBigBoy]

If you really look at the left hand area - it looks like you may have a reversing loop within a reversing loop. Am I correct or not?

 

[Rocky Lines]

Thanks, I got the answer I needed from another source.