D&J RailRoad
Professor of HO
Last evening I noticed one of my power districts was shorted out. I had been tinkering with a locomotive project for awhile and just didn't have the ambition to start troubleshooting this.
Today, that was priority one, find the short. I had recently put several locomotives on the rails, BLI with the older, high draw decoders. I took those off the track but still the short was there. I checked all the turnouts in that section but they were all good.
I had been installing 28" wheels on auto racks over the past couple days and two of them had metal trucks. OK, which ones were they. Turns out, the shorted metal trucks didn't short all the time, so I ended up removing them all from the track until the short was truly gone and the two BLI locos ran without stuttering.
I found the two auto racks and discovered that I had installed the 28" wheels with the insulation reversed on the two axels of one truck on each car. I corrected them and put the auto racks back on the track. The locos continued to stutter though. Looking closer though I discovered that the truck frames were close enough to the rails to arc. OK, I pulled those trucks of and replaced them with the plastic trucks with the 28" wheels installed.
All better now.
Today, that was priority one, find the short. I had recently put several locomotives on the rails, BLI with the older, high draw decoders. I took those off the track but still the short was there. I checked all the turnouts in that section but they were all good.
I had been installing 28" wheels on auto racks over the past couple days and two of them had metal trucks. OK, which ones were they. Turns out, the shorted metal trucks didn't short all the time, so I ended up removing them all from the track until the short was truly gone and the two BLI locos ran without stuttering.
I found the two auto racks and discovered that I had installed the 28" wheels with the insulation reversed on the two axels of one truck on each car. I corrected them and put the auto racks back on the track. The locos continued to stutter though. Looking closer though I discovered that the truck frames were close enough to the rails to arc. OK, I pulled those trucks of and replaced them with the plastic trucks with the 28" wheels installed.
All better now.