Railroadkid1937
Member
So My paragon 2 Hudson arrived in the mail today and to my surprise it didn't work! What happened was I put it on the track, programmed it to the address I wanted ran it for a couple minutes then shut the power off. It turns out that when I went to turn the power on again the train wouldn't run. So I reset t to factory default (08-08) and that seemed to work ok until I shut off power again. I even went and physically pressed the button that was inside the decoder and did it the way broadway limited described on the site but even that was fruitless. Anyway my question is, has anyonw had that problem before and if so can you please help me find a way to fix it?
Thanks in advance everyone,
Clint
Thanks in advance everyone,
Clint