Recent content by Stumpy

Excavator is WS. Dozer is 3D printed.

Decapod pulling out of the coal mine, then crossing the river.

Great pics.

Fine looking build!

33 and rain. After the rain it's going to rain. Then it's supposed to rain tomorrow and Monday and Tuesday. Some new equipment ready to go to the coal mine.

You should. A lot less joints & soldering.

https://dccwiki.com/PECO_Electrofrog

Had a section of "bullet proof" track, in a not-removable tunnel section turn not-bullet proof this week. Camper of happiness I am not.

The following was copied from an email I received a moment ago. Let’s put money directly in your pocket* eBay now manages the end-to-end selling experience on our marketplace, including payments. This means: • No more PayPal payment processing fees. • You get paid directly to your...

Jordan kit finished today. The Hansen boys are first rate builders, but they are hard on vehicles.

In the middle of the R&R room. Reloading on two walls and railroad on two walls.

About the same size as you have pictured.

Prieser figures definitely. I use others, but only if they are far from the eye. Mostly Wiseman and Jordan kits for autos. Although Euro makers Ricko, Roskopf, Busch & Praline make some nice RTR American vehicles. WS white metal kits leave a bit to be desired. But, to be fair, I imagine most...

I do sorta the same thing. The white wire in the 4th pic in the OP. I solder the foot of the "L" to the outside of the rail, them push/pull the wire through the hole. Yours makes a much less noticeable connection.

Agree. If you want a quiet compressor this one is the ticket. I bought it because I needed a small, portable compressor (really portable not the 75 lb. "portable" compressor I have in my shop), so I wasn't paying any attention to the "quiet" aspect, but it is - surprisingly so. You can be in...